中间这个就是果盒LITE ，可以看出他和SFC手柄的大小比较

打印了一堆盒子，发现拉丝还是很严重。打印机的锅

从左到右是香蕉派、香蕉派、果盒lite
-----------------------------------------------------------------


小街机，侧面保护纸没有拆下来
------------------------------------------------------------------
剩下的就是一堆杂物以及各种不知道什么时候才能填上的坑


这样的一堆，我家还有4堆，这个算是比较挣得的摆放的，其他的太反胃，不照了。



这两个盒子里每一个塑料袋，都是一种螺丝。



这个坑，实在没空填。



小街机第一版，按照老外的思路粘出来的，然而各种无法承重。

posted by wap, platform: iPhone
如果真是用的nanoPi M2，那确实没赚什么钱，光nanopi M2 1g内存版的板子就要160多了，不过既然都花160买四核A9了，为什么不干脆买219的树莓派3呢？

应该是nanopi m1，外壳太不美观了，淘宝上10元不到的壳要好很多。

引用:

原帖由 ahliang 于 2016-7-1 00:08 发表
应该是nanopi m1，外壳太不美观了，淘宝上10元不到的壳要好很多。

nanopi M1就是个坑，电源管理有问题，发热严重，不配风扇就是找死，渣渣
http://forum.armbian.com/index.p ... board-buyers-guide/
Quite the opposite with BPi M2+. For whatever reasons SinoVoip put the same programmable voltage regulator on their board as OPi One, Lite and NanoPi have but does not implement voltage switching so H3 there will always be fed with 1.3V. In addition it seems 'Team BPi' didn't take care of heat dissipation through PCB design (it seems Xunlong added a copper layer to the PCB that helps dramatically spreading the SoC's heat) and so with BPi M2+ (and NanoPi M1 too) you have to be prepared that you need both a heatsink and a fan to let this board perform under full load since otherwise heavy throttling occurs or when you use a kernel that does not implement throttling (4.6/4.7 right now for example) be prepared that H3 gets either destroyed or will crash through overheating if you run something heavy on BPi M2+ or NanoPi M1.

[ 本帖最后由 china_ktv 于 2016-7-1 08:12 编辑 ]